Dog Kennel Anchor Kit
Each kit includes four anchors, a drive rod, and four
wire rope clamps. This prepackaged kit requires no digging and is
excellent for anchoring kennels, playground equipment, trees, fencing and
more! Package Size: 37"x7"x2.25".
Rapid Ship Program
This item is usually shipped out within 1 - 2 business days.
ANCHOR KIT - Easy As 1-2-3
Installation Instructions
Step 1 Move kennel to the area where it is to
be anchored.
Step 2 Begin by gathering one anchor, the
driving rod and a large hammer (5 lb. Sledge works best). Begin at one corner
of the kennel. Insert the driving rod into the anchor and begin driving the
anchor next to the bottom corner rail of kennel.
Step 3 Drive the anchor down to the desired
depth being sure to leave enough of the cable above ground to secure around
the kennel frame.
Step 4 Remove the driving rod. Wrap the
exposed wire around the driving rod and pull upward four to five inches to "lock"
the anchor into the ground.
Step 5 After the anchor is “locked”, gather
a wire clamp and wrap the wire around the corner vertical frame rails of the
kennel so that the wire clamp will be to the outside of the kennel. Attach the
wire clamp around the wire and tighten.
Step 6 Repeat the above steps for the remaining
corner of the kennel.
Note: All underground work requires proper safety and location procedures. Do
not install anchor kit until you know what is below the surface. It is important
that all anchors be fully locked before being put to use.